XK-W2001 Adjustable Temperature Controller Socket with 1M Probe and AU Plug

===================================================
XK‑W2001 ADJUSTABLE TEMPERATURE CONTROLLER
(Socket + 1 m Probe + AU Plug)
===================================================

📌 Device Type:
Digital thermostat/temperature controller with integrated
AC socket and external temperature probe. :contentReference[oaicite:1]{index=1}

🔌 Power & Socket:
• **Input Voltage:** AC 110–220 V (wide range) :contentReference[oaicite:2]{index=2}
• **Plug Type:** AU plug (Australian socket style) :contentReference[oaicite:3]{index=3}
• **Output Capacity:** Max ~10 A, ~1500 W load :contentReference[oaicite:4]{index=4}

🌡️ Measurement & Control:
• **Temperature Sensor:** Waterproof NTC10K probe (1 m cable) :contentReference[oaicite:5]{index=5}
• **Temp. Measure Range:** −50 °C to +110 °C :contentReference[oaicite:6]{index=6}
• **Control Accuracy:** ~0.1 °C :contentReference[oaicite:7]{index=7}
• **Display:** Digital LED shows current and set temperatures :contentReference[oaicite:8]{index=8}

📊 Functions & Modes:
1. **Temperature Set‑Point (P0):** Set starting temp. :contentReference[oaicite:9]{index=9}
2. **Stop Temperature (P1):** Set cutoff temp. :contentReference[oaicite:10]{index=10}
3. **Calibration (P2):** Adjust offset to match true temp. :contentReference[oaicite:11]{index=11}
4. **Delay Start (P3):** Set start delay (minutes) before switching output. :contentReference[oaicite:12]{index=12}

🧠 How It Works (Basic Logic):
• **Place Probe** in the environment where temperature is to be monitored. :contentReference[oaicite:13]{index=13}
• **Plug Controller** into the mains (110‒220 V). :contentReference[oaicite:14]{index=14}
• **Connect Device** (heater/cooler) to the controller socket. :contentReference[oaicite:15]{index=15}
• Controller **reads temperature** via probe and **switches output ON/OFF**
to maintain desired temperature range. :contentReference[oaicite:16]{index=16}

🔧 Typical Use Cases:
• Aquarium temp. regulation
• Home incubators
• Brewing and fermentation temp. control
• Freezer/Chiller thermostatic control
• Water tank / pet habitat climate control
• Industrial process temp. control :contentReference[oaicite:17]{index=17}

🛠️ Notes for Setup:
• Ensure load on controller does not exceed ~1500 W. :contentReference[oaicite:18]{index=18}
• Place waterproof probe where good airflow/heat transfer occurs. :contentReference[oaicite:19]{index=19}
• Use heating mode if set temp > ambient, cooling mode otherwise. :contentReference[oaicite:20]{index=20}