Float Level Switch SEN-PPI110
💧 Float Level Switch SEN-PPI110
🧩 Overview
Mechanical liquid level detection switch
Uses floating mechanism with magnetic reed switch
Designed for water tanks & liquid level control
Works without continuous power (passive device)
⚙️ Working Principle
Float contains a magnet inside
As liquid level rises/falls, float moves
Magnetic field activates reed switch
Output changes:
ON → level reached
OFF → level dropped
👉 Provides ON/OFF signal for level detection
📊 Key Specifications
🔹 Material: Polypropylene (PP plastic)
🔹 Operating Temperature: 0°C – 60°C
🔹 Max Voltage: Up to DC100–2000V (model dependent)
🔹 Max Current: ≤ 0.5A
🔹 Switch Type: Normally Open (NO) / Normally Closed (NC configurable)
🔹 Mounting Type: Vertical (threaded shaft, usually M10)
🔹 Response Time: ~0.2 ms
🔹 Cable Length: ~30 cm (typical)
🔌 Output Type
Simple 2-wire switch output
Works like a digital switch (HIGH/LOW)
Can be connected to:
Microcontroller (via pull-up)
Relay module
Pump control circuit
🔄 Features
No external power required for sensing
Simple and reliable design
Corrosion-resistant PP material
Easy installation in tanks
Long mechanical life (millions of cycles)
🛠️ Applications
Water tank level control 💧
Automatic pump ON/OFF systems
Overhead tank monitoring
Humidifiers & water dispensers
Industrial liquid level control 🏭
⚠️ Usage Tips
Use relay for high voltage loads (pump/motor)
Install vertically for accurate switching
Ensure liquid is non-corrosive to PP material
Avoid turbulence near float
Seal threads properly to prevent leakage
✅ Advantages
Very low cost
No complex electronics
Reliable ON/OFF switching
Easy to integrate
⚠️ Limitations
Only point level detection (not continuous measurement)
Mechanical movement → possible wear over time
Not suitable for viscous or dirty liquids
Limited current handling
🔍 Summary
A simple float-based level switch
Uses magnetic reed switch for detection
Outputs digital ON/OFF signal
Ideal for automatic water level control systems
